Basting - Pfaff 8310-041 Instruction Manual

Sealing
10

Basting

.04
With the basting function sealing is performed point for point (without feed stroke) in accor-
dance with specified parameters.
●
●
Description of the functions
Sealing
This function is used to change to the sealing mode.
Sealing power
These functions are used for altering the sealing power, see Chapter 9.03.01 Entering the
sealing power or the sealing amplitude
Sealing amplitude
These functions are used for altering the sealing amplitude, see Chapter 9.03.01 Entering
the sealing power or the sealing amplitude
Hold time
These functions are used to alter the time, after which the top roller is raised again after the
end of the sealing time
Sealing time
These functions are used to alter the sealing time.
Roller pressure
These functions are used to alter the roller pressure, see Chapter 9.03.03 Entering the rol-
ler pressure.
●
●
36
Call up manual sealing or dynamic sealing, see Chapter 9.02 Selecting a program.
Call up basting.
Power sealing (standard)
Enter the parameter for basting according to the material to be sealed.
Start the basting operation with the pedal function "+1", see Chapter 7.03 Pedal.
Amplitude sealing