Installing Or Removing The Compact Flash Memory Card - Cisco IE 3000 Hardware Installation Manual

Chapter 2 Switch Installation

Installing or Removing the Compact Flash Memory Card

Figure 2-6 Pushing the Module Latches In
If you are going to install a second expansion module to the switch expansion module combination,
Step 6
follow Step 1 through Step 5.
Refer to Table 2-1 for a list of supported switch and expansion module combinations.
Note
If you are attaching an IEM-3000-4PC or IEM-3000-4PC-4TC PoE expansion module to the switch, you
must also connect the expansion modules to source DC. Source DC can come from either the
PWR-IE65W-PC-DC, a DC-input power supply, the PWR-IE65W-PC-AC, an AC-input power supply,
or from site source DC; however, the site source power voltage must be 48-54VDC.
Installing or Removing the Compact Flash Memory Card
The switches store Cisco IOS software images and switch configurations on a removable flash memory
card. You can replace the switch without reconfiguring it. The switch ships with the compact flash
memory card installed. Verify that the card is in place on the bottom of the switch.
Cisco IE 3000 Switch Hardware Installation Guide
2-12