Connecting Modules - Cisco IE 3000 Hardware Installation Manual

Adding Modules to the Switch

Connecting Modules

Expansion modules are not hot-swappable. You must turn off power to the switch before adding or
Note
removing an expansion module.
To connect the expansion modules to the switch, follow these steps:
Remove the side panel of the switch by firmly grasping both sides of it in the middle and pulling it
Step 1
outward. If necessary, use a screwdriver to pry open the side panel. See
Figure 2-2
Remove the EMI protective cover from the interface connector on the switch. See
Step 2
Figure 2-3
Cisco IE 3000 Switch Hardware Installation Guide
2-10
Opening the Side Panel of the Cisco IE-3000-8TC Switch
Removing the EMI Cover
Chapter 2 Switch Installation
Figure 2-2.
Figure 2-2.