Garmin VARIA Owner's Manual page 15

Installing the Out-Front Mount
You can use the out-front mount to install both
an
Edge~
device and a headlight.
1
Select a secure location to mount the Edge
device and headlight where they do not
interfere with the safe operation of your
bike.
2
Use the hex key to remove the screw
G)
from the handlebar connector @.
3
If necessary, remove the two screws on the
top of the mount @, rotate the connector,
and replace the screws to change the
orientation of the mount for an Edge
device.
4
Place a rubber pad around the handlebar:
• If the handlebar diameter is 25.4 mm,
use the thicker pad.
• If the handlebar diameter is 31 .8 mm,
use the thinner pad.
5
Place the handlebar connector around the
rubber pad.
NOTE: You should align the contours on
the rubber pad with the grooves on the
inside of the handlebar connector.
Instructions
3