Stamina 1201 Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
STEP 4
There is an "R" decal on the RIGHT PEDAL CAP(20R), and a "L" decal on the LEFT PEDAL CAP(20L).
Insert the PEDAL SHAFT(15) through hole on the PEDAL SUPPORT(10). Place a SPACER(21) and the
RIGHT PEDAL CAP(20R) onto right end of the PEDAL SHAFT(15). Place a SPACER(21) and the LEFT
PEDAL CAP(20L) onto left end of the PEDAL SHAFT(15). Slide the RIGHT and LEFT PEDAL CAPS(20R,
20L) toward the CENTER BEAM(16) and secure with WASHERS(M8)(46) and NYLOCK NUTS(M8x1.25)
(48) at both sides of the PEDAL SHAFT(15). Press the NUT CAPS(35) onto the NYLOCK NUTS(M8x1.25)
(48).
NOTE: You need to use two wrenches to tighten the NYLOCK NUTS(M8x1.25)(48) at both ends of the
PEDAL SHAFT(15) at the same time.
STEP 5
Install an AA battery into the METER(25), the battery is not included. See page 11 for detailed battery
installation instructions. Plug the SENSOR WIRE(26) to the METER(25), and push the excess wires back
into the CENTER BEAM(16). Slide the METER(25) to the plate on the PEDAL SUPPORT(10).
35
48 20L
46
L
25
15
21
R
26
10
20R
21
46
16
48
35
9