Connecting A Pc - Philips BDS4222B User Manual

DVI IN RGB IN
RGB cable
(15 P in D-S ub )
PC/NOTEBOOK PC/NOTEBOOK
A udio L/ R
(2 x RCA cables )
ANT
SCART INPUT (2x)
A udio L/ R
(2 x RCA cables )
5.5
Using RGB(VGA) or DVI Video Input
RGB OUT RS-2
1 Connect the 15-pin D-Sub RGB(VGA) connector of the PC to the
2 For both RGB(VGA) and DVI, connect the red (R) and white (L)
OTHER RGB
Note:
MONITOR
A RGB(VGA) loop-out labeled "RGB Out" will allow another
RGB(VGA) monitor to be connected. The RGB(VGA) loop-out will
display the same signal as the RGB In signal source.
Setting Up Your Display Using Plug and Play
This display adheres to VESA Plug and Play standard to eliminate
complicated and time consuming setup of monitors. This monitor
identifies itself to the computer and automatically sends the PC its
Extended Display Identification Data (EDID) using Display Data Channel
(DDC) protocols.
How to Set up Your PC for Use with Monitor (Windows)
The display settings for a typical Windows-based computer are shown
below. However, the actual screens on your computer will differ
depending on the version of Windows and video card equipped with the
computer. Even though the actual screen may look different from
example displayed below, basic set-up routine will apply in most cases.
1 Go to the Window's CONTROL PANEL by clicking START,
2 Select the DISPLAY icon from this window.
3 Select the SETTINGS tab to display your computer's video output
4 Set the "Screen Resolution" settings to 1024x768 PIXELS. For
5 If a vertical-frequency option is available, set the value to 60 or
6 Click OK to complete the setting.
Note:
Both screen position and size will vary, depending on the type of PC
graphics card and its resolution selected. See page 45 for an overview of
the supported resolutions.

CONNECTING A PC

RGB-IN connector of the monitor.
If you have a PC that is equipped with a DVI (Digital Visual Interface),
you may connect the PC DVI connector from the PC to the DVI-IN
connector of the monitor.
audio jacks of the PC to the R and L (DVI/RGB) AUDIO IN jacks of
the monitor.
SETTINGS, CONTROL PANEL.
=> The CONTROL PANEL Window is displayed.
=> The DISPLAY PROPERTIES dialog box is displayed.
settings.
COLOR QUALITY, select 24 BIT COLOR (might also be expressed
as 16 million colors).
60 Hz.
19
User Manual BDS4222B/V/R