Advertisement
Description of CS (Control Station)
1. System Power Button
S1
S2
S3
S4
2. Source Select Control Button
3
1
MAIN
POWER
1
2
5
VOLUME
IR
3
4
S
MAIN POWER (
) button
– Press to turn the Control Station on. The LED
indicators and 1 source LED indicator will illu-
minate.
– Press to turn the Control Station off. The LED
indicators will turn off and the MAIN POWER
(
) (1) will dimmed.
– Press the source SELECT (S) button (2) to step
through the different Audio/Video Input Sources,
each press button of the SELECT (S) button
(2) will advance to the next input source. The
source indicator LED (3) will light in the follow-
ing sequences:
– Before attempting to operate the Remote Con-
trol, press and hold the source SELECT button
(2) for 6 seconds until the source indicator LED
4
(3) begins flashing. Once the indicator is blink-
ing the Control Station will accept Infrared in-
put command signals from an Infrared Remote
6
Control device. To remove the Infrared Control
function from the Control Station press and hold
the button for 3 seconds.
2
– If source indicator LED (3) is blinking the S1
position, the Control Station has selected to
control the Audio/Video Input at Source 1. To
change the sources, press the source SELECT
button (2) to view the following sources.
3. Source Indicator LED
– Indicates the video source that can will be
viewed.
4. Remote Sensor Eye
– When the source indicator LED (3) is flashing,
this indicates that the source equipment can
be controlled remotely by pointing the remote
control device at the remote device sensor.
5. Volume Up/Down Button
– Press the "+" button to increase headphone
volume.
– Press the "–" button to decrease headphone
volume.
S1
S2
S3
S4
Advertisement
