Troy-Bilt TB 510 SERIES Operator's Manual page 8

Grass Catcher Assembly
1. Follow steps below to assemble the
grass catcher (if needed). Make certain
bag is turned right side out before
assembling (warning label will be on the
outside). See Figure 2-4.
a. Place bag over frame so that
its black plastic side is at the
bottom.
b. Slip plastic channel of grass bag
over hooks on the frame.
B
Figure 2-4
Set-Up
Checking the Battery Charge Level
Press the charge meter button on the battery.
See Figure 2-5. The number of lights that
illuminate will indicate the current charge
level of the battery. If all four lights are dark,
charge the battery before any further use. See
Charging Battery on page 8 in the Assembly &
Set-Up section.
25% - 50% 50% - 75%
0% - 25%
Charge Meter But ton
Figure 2-5
NOTE:
While in use, lithium-ion batteries
provide power with minimal power fade.
When the battery is fully discharged, it will
immediately cut power to the mower and
require charging.
WARNING: Do not expose the
mower to rain or wet conditions.
8 S 2 — A
ection SSembly
Charging Battery
IMPORTANT:
mower, follow the steps below for charging
the battery. The battery is not shipped fully
charged.
NOTE:
Lithium-ion batteries will not develop
a memory and may be charged at any time.
For maximum run time, fully charge the battery
before each use.
1. Plug the battery charger into an
appropriate Ground Fault Circuit
Interrupter (GFCI) power outlet. See
manual shipped with battery charger.
2. Insert the battery into the charging
dock. The LED should illuminate.
See Figure 2-6.
A
LED
NOTE:
If LED does not light:
• Make sure the battery is fully inserted
into the charging dock.
• Make sure the battery charger is fully
plugged into an appropriate power
outlet.
• Make sure the power outlet is
functioning by testing it with another
electrical device.
75% - 100%
& S -U
et p
If battery is included with the
Figure 2-6
3. Examine the LED. The LED will indicate
the battery status:
• Green (blinking): The battery is
charging. Charge the battery until the
green light stops blinking.
• Green (constant): The battery is fully
charged.
• Red (blinking): The battery and/or
charger are too hot or too cold. Make
sure the battery and charger are in an
environment between 32° and 104° F
(0° and 40° C). Allow time for the battery
and/or charger to warm up or cool
down.
• Red (constant): The battery is no longer
functional. Refer to the Warranty section
for replacement information.
4. Once the battery is fully charged,
remove it from the battery charger.
NOTE:
The battery can be stored in the
battery charger, but the battery charger
should be unplugged from the power
outlet.
Grass Catcher
1. Follow steps below to attach grass
catcher to mower. See Figure 2-7.
a. Lift mower rear discharge door.
b. Place grass catcher into the slots
in the handle brackets. Release
discharge door so that it rests on
the grass catcher.
B
B
Figure 2-7
To remove grass catcher, lift mower rear
discharge door. Lift grass catcher up and off
the slots in the handle brackets. Release mower
rear discharge door to allow it to close.
A