Table of Contents
Advertisement
Chapter 8
Managing PNNI Nodes and PNNI Routing
Remote node name.......SanJose
Remote node id.........56:160:47.00918100000000309409f1f1.00309409f1f1.01
Upnode id..............0:0:00.000000000000000000000000.000000000000.00
Upnode ATM addr........00.000000000000000000000000.000000000000.00
Common peer group id...00:00.00.0000.0000.0000.0000.0000.00
node index
Local port id:
Local Phy Port Id: 11:2.1:33
Type. lowestLevelHorizontalLink
Derive agg...........
SVC RCC index........
Remote node name.......SanJose
Remote node id.........56:160:47.00918100000000309409f1f1.00309409f1f1.01
Upnode id..............0:0:00.000000000000000000000000.000000000000.00
Upnode ATM addr........00.000000000000000000000000.000000000000.00
Common peer group id...00:00.00.0000.0000.0000.0000.0000.00
Displaying the PNNI Routing Policy
Enter the dsppnni-routing-policy command to display the routing policies used for background routing
tables generation.
mgx8830a.1.PXM.a > dsppnni-routing-policy
The following example shows the report for this command:
mgx8830a.1.PXM.a >
SPT epsilon.........
SPT holddown time...
SPT path holddown time
CTD Background Table
mgx8830a.1.PXM.a >
Table 8-18
Table 8-18 Objects Displayed for the dsppnni-routing-policy Command
Parameter
SPT epsilon
SPT holddown
SPT path holddown time
CTD Background Table
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
: 1
17504289
dsppnni-routing-policy
describes the objects displayed for the dsppnni-routing-policy command.
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Hello pkt TX.........
Remote port id:
17045537
Hello state....... twoWayInside
0
Intf index...........
0
Hello pkt RX.........
Hello pkt TX.........
0
Load balance........
1
On demand routing...
2
AW Background Table
on
CDV Background Table
Description
The tolerance used during route calculation to
determine which paths qualify as equal-cost. The
range is from 0 – 20.
The interval between two consecutive
calculations for generating routing tables. The
range is from 1 (0.1 sec) to 600 (60 sec).
The minimum time that can elapse between
consecutive calculations that generate routing
tables for border nodes. The range is from
2 (0.2 sec) to 600 (60 sec).
Displays whether CDT
routing table is enabled or disabled. CTD is the
time interval between a cell exiting source node
and entering the destination node.
Displaying Node Configuration Information
19582
17504289
17501
18877
random
best fit
on
on
1
for the background
8-53
Advertisement
Table of Contents
Troubleshooting
