Cisco SCE 8000 Installation And Configuration Manual page 240

Warning Messages, Severity Level 4
Warning Message %LOCAL7-4-DBG_INIT_FAILED_AFTER_HC2: "DBG Init failure
Explanation
file fails. This operation is attempted when there is an error in the header obtained from the second
debug log file because it is corrupted, that is, the file is not in the full, empty, or active state.
Recommended Action
Warning Message %LOCAL7-4-DBG_INIT_BOTH_FULL: "DBG Init problem
Explanation
log files are in the full state. Close the existing files and create or open a new file.
Recommended Action
Warning Message %LOCAL7-4-DBG_INIT_FAILED_AFTER_BF: "DBG Init failure
Explanation
the existing file is closed, with the status of the headers obtained from both the debug log files in the
full state.
Recommended Action
Warning Message %LOCAL7-4-DBG_INIT_BOTH_ACTIVE: "DBG Init problem
Explanation
log files are in the active state. Close the existing second file and create a new first file or open an
existing first file.
Recommended Action
Warning Message %LOCAL7-4-DBG_INIT_FAILED_AFTER_BA: "DBG Init failure
Explanation
existing log file is closed and when the status of the headers obtained from both the debug log files
are in the full or active state.
Recommended Action
Warning Message %LOCAL7-4-DBG_DEVICE_CREATION_FAILED: "DBG Init failure
Explanation
Recommended Action
Cisco SCE8000 GBE Installation and Configuration Guide
C-44
This warning message is generated when the open or create operation of a new debug
None.
This message is generated when the status of the headers obtained from both the debug
None.
This message is generated when the create or open operation of a new file fails when
None.
This message is generated when the status in the headers obtained from both the debug
None.
This message is generated when the task of creating or opening a new file fails after the
None.
This message is generated when the creation of a logger device fails.
None.
Appendix C Cisco Service Control Engine System Log Messages