Convenience Closing Feature - Mercedes-Benz B-Class Electric Drive Operator's Manual

Convenience closing feature

Important safety notes
G
WARNING
When using the convenience closing feature,
parts of the body could be trapped in the clos-
ing area when a side window is being closed.
There is a risk of injury.
Observe the complete closing procedure
when the convenience closing feature is oper-
ating. Make sure that no body parts are in
close proximity during the closing procedure.
Vehicles with KEYLESS-GO or the Exclusive
package: when you lock the vehicle, you can
close the side windows at the same time.
i
Notes on the automatic reversing feature for
the side windows (
Y
Using the SmartKey
Vehicles with the Exclusive package but
X
without KEYLESS-GO: for the following
operations, point the tip of the SmartKey at
the door handle on the driver's door. The
SmartKey must be close to the driver's door
handle.
i
Vehicles with KEYLESS-GO: the SmartKey
must be in close proximity to the vehicle.
Press and hold the & button until the side
X
windows are fully closed.
To interrupt convenience closing: release
X
the & button.
Using KEYLESS-GO
The driver's door and the door at which the han-
dle is used, must both be closed. The SmartKey
must be outside the vehicle. The gap between
the SmartKey and the corresponding door han-
dle should not be greater than 3 ft (1 m).
page 75).
Touch recessed sensor surface : on the
X
door handle until the side windows are fully
closed.
i
Make sure you only touch recessed sensor
surface :.
Make sure that all the side windows are
X
closed.
To interrupt convenience closing: release
X
recessed sensor surface : on the door han-
dle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock ( page 109).
Y
Pull the corresponding switch on the door
X
control panel until the side window is com-
pletely closed ( page 76).
Y
Hold the switch for an additional second.
X
If the side window opens again slightly:
Immediately pull the corresponding switch on
X
the door control panel until the side window is
completely closed (
Y
Hold the switch for an additional second.
X
If the respective side window remains closed
X
after the button is released, then it has been
set correctly. If this is not the case, repeat the
steps above again.
Side windows
page 76).
Z
77