Table of Contents
Advertisement
Maintenance & Care
When you're done
1. Push power pedal OFF.
2. Unplug power cord from outlet.
3. Remove and empty collection tank.
3a. Release collection tank latches [1 each side] by
pulling up from bottom of latch and then out.
3b. Carefully remove collection tank from lower body
by lifting handle.
3c. Carry collection tank to a toilet or sink. To empty,
pour out contents using opening at back of tank.
3d. Rinse collection tank thoroughly.
3e. Remove vent cover from top of collection tank by pulling the tab on top and pulling up.
Remove foam filter from vent cover. Rinse filter thoroughly and replace back into vent cover.
Replace vent cover back into collection tank, making sure the tab clicks back into the locked
position.
4. Remove lint and hair from red gasket in base of unit. (Do not remove gasket)
5. Clean nozzle window by lifting latch and removing from machine. Rinse under running water.
When finished replace nozzle and secure with latch.
6. Replace collection tank on lower body and secure with latches.
7. Wrap power cord around Quick Release™ Cord Wrap on side of deep cleaner.
8. Wipe all surfaces with a soft cloth. Store cleaner upright in a protected, dry area.
NOTE: You may have cleaning solution remaining in the clean water/solution tank. You may
store your deep cleaner this way for the next cleaning task, but never keep soiled solution in the
collection tank.
Troubleshooting
Problem
Possible causes
Clean water/solution tank empty.
Reduced spray
OR
Clean water/solution tank cap clogged.
no spray
Collection tank not aligned/secured.
Collection tank full.
Deep cleaner
Removable nozzle installed improperly.
not picking
up cleaning
solution
Removable nozzle full of debris.
Red lint screen under collection tank
clogged.
Please do
not return
this product
to the store.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
WARNING
To reduce the risk of electric shock, push power pedal
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
CAUTION
Do not store unit where freezing may occur. Damage to
internal components may result.
WARNING
To reduce the risk of electric shock, push power pedal
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Refill tank with water and formula.
Soak tank cap in warm water and then
rinse under running water.
Check tank for proper alignment and
secure with side latches.
Empty tank.
Align four "hooks" into bottom first, then
snap into place on top.
Remove nozzle and rinse under running
water.
Remove debris from lint screen.
www.BISSELL.com
7
Advertisement
Table of Contents
