Kenwood KDC-X301 Instruction Manual page 22

BLUETOOTH®
Make a call
You can make a call from the call history, phonebook, or
dialing the number. Call by voice is also possible if your
mobile phone has the feature.
1
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
again to switch to another phone.
"(Second device name)" appears.
2
Turn the volume knob to select an item (see the
following table), then press the knob.
3 2
Repeat step until the desired item is selected/
activated or follow the instructions stated on the
selected item.
4
Press and hold to exit.
To return to the previous setting item, press
CALL HISTORY (Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a
phone number.
•
"OUTGOING", or "MISSED" is shown on the
lower part of the display to indicate the
previous call status.
call received, "O" indicates call made, "M"
indicates call missed.
• Press DISP to change the display category
(NUMBER or NAME).
• "NO DATA" appears if there is no recorded call
history.
2 Press the volume knob to call.
18
ENGLISH
.
/ : "INCOMING",
/ : "I" indicates
* Functionality depends on the type of the phone used.
PHONE BOOK (Applicable only if the phone supports PBAP.)
1 Turn the volume knob quickly to enter alphabet search mode (if the phonebook
contains many contacts).
The first menu (ABCDEFGHIJK) appears.
• To go to the other menu (LMNOPQRSTUV or WXYZ1*), press J / K.
• To select the desired first letter, turn the volume knob or press S / T, then
press the knob.
Select "1" to search with numbers and select "*" to search with symbols.
2 Turn the volume knob to select a name, then press the knob.
3 Turn the volume knob to select a phone number, then press the knob to call.
• The phonebook of the connected phone is automatically transferred to the unit when
pairing.
• Contacts are categorized as: HOME, OFFICE, MOBILE, OTHER, GENERAL or HM (home),
OF (office), MO (mobile), OT (other), GE (general)
• This unit can display only non-accent letters. (Accent letters such as "Ú" is showns as
"U".)
1 Turn the volume knob to select a number (0 to 9) or character ( , #, +).
NUMBER DIAL
2 Press S / T to move the entry position.
Repeat steps
3 Press the volume knob to call.
(or using the remote control)
1 Press the number buttons (0 to 9) to enter the phone number.
2 Press to call.
VOICE Speak the name of the contact you want to call or the voice command to control the phone
functions. ( 19, Make a call using voice recognition)
BATT LOW/MID/FULL * : Shows the strength of the battery.
NO SIGNAL/LOW/MID/MAX * : Shows the strength of the current received signal.
1 2
and until you finish entering the phone number.