Cisco Nexus 9372TX Hardware Installation Manual page 27

Installing the Switch Chassis
1 Slider rail with screw holes aligned to screw holes in
rack
c) Repeat Step 3 to attach the other slider rail to the other side of the rack.
To make sure that the slider rails are at the same level, you should use a level tool, tape measure, or carefully count
the screw holes in the vertical mounting rails.
Step 5
Insert the switch into the rack and attach it as follows:
a) Holding the switch with both hands, position the two rear rack-mount brackets on the switch between the rack or
cabinet posts that do not have slider rails attached to them (see the following figure).
2
Cisco Nexus 9372TX and 9372TX-E NX-OS Mode Switches Hardware Installation Guide
Two customer-supplied 12-24 or 10-32 screws used
to attach each slider rail to the rack
Installing the Switch
17