Thread Guide Plate - Janome 1600P Servicing Manual

(5)
2.7 mm
(4)
(3)
2.7 mm
(2)
1.4 mm

3. Thread Guide Plate

[1] Remove the needle plate.
[2] Loosen the flat screw (1) and adjust the position of
the thread guide plate (2).
[3] The left inner edge (3) of the thread guide plate
should be approximately 1.4 mm from the center of
the needle drop position (4) and the back inner edge
(5) of the thread guide plate should be approximately
2.7 mm from the center of the needle drop position (4).
(Use the first step from the left of the Gauge 767G-001
for 2.7 mm).
[4] Tighten the flat screw firmly. Attach the needle plate.
(1)
23