8-5. Replacing the PI controller
If the PI controller has been replaced, clear the comparison data.
Carry out the procedure below for the PI controller to be replaced.
Select [PI Controller] as the "Target".
Select the AE-50 or EW-50 the PI controller is connected to as the "Centralized controller".
(With each touch, the display changes in the following sequence: [Exp1]→[Exp2]→[Exp3]→[Exp4].)
Select the address of the connected PI controller as the "PI Controller".
If you inadvertently select the PI controller which has not been replaced, the unapportioned pulse increment will
be discarded.
After the settings are completed, touch [Clear].
122
WT07442X02