Notice
1. Attaches UPPER CASE assembly
The screw hole (a4) is weaker than the others
(a1),(a2) and (a3).
Tighten this screw carefully in accordance with
screw torque below.
Screw torque : 0.6 to 0.9Nm(6 to 9kgm)
(a3)
(a2)
(a4)
Bottom of the projector
2. Removes POWER BOARD(CIRCUIT)
(1) Unscrew two screws and remove a plastic rivet,
and then get the BALLAST-BRACKET off.
screw
screw
plastic rivet
CP-S335(C9SM)/CP-X340(C9X)/CP-X345(C9XM)
(a1)
BALLAST-BRACKET
(2) Take the Power Center Sheet and the Power
Side Sheet off.
Next, get POWER BOARD(CIRCUIT) off as
unclipping three holders and a POWER-
BRACKET hook.
POWER-BRACKET
hook
holder
holder
NOTE:
In removing POWER BOARD(CIRCUIT), use
flat screw driver or fine tool to unclip the holder
with the arrow shown below.
38
Power Side Sheet
Power Center Sheet
holder
POWER-BRACKET
POWER BOARD
(CIRCUIT)