Table of Contents
Advertisement
8
1.
POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System, and Recoil Starter.
2.
GRIP - Rear (right hand) handle.
3.
STOP SWITCH - "SLIDE SWITCH" mounted on top of the Throttle Trigger Housing. Move switch FORWARD to
RUN, BACK to STOP.
4.
FRONT HANDLE - The Front (loop) handle is factory assembled to the Drive Shaft Assembly and must be posi-
tioned for proper cutting position and operator comfort.
5.
DRIVE SHAFT ASSEMBLY - Includes the Rear (right hand) Handle assembly, Gear Housing assembly, Front (loop,
left hand) Handle assembly, Flexible Drive Cable and Safety Decal.
6.
DEBRIS SHIELD/FLAP - Mounted over the cutting attachment. Helps protect operator by deflecting debris
produced during the edging operation.
7.
BLADE - Rotates to provide cutting action.
8.
WHEEL - Adjustable up/down, sets depth of blade.
9.
THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration, press trigger gradually
for best operating technique.
10. CHOKE - The choke control is located on the top of the air filter case. Move choke lever to "Cold Start" to close
choke for cold starting. Move choke lever to "Run" position to open choke.
11. SPARK PLUG - Provides spark to ignite fuel mixture.
12. TOP GUARD - Protects arm from the hot engine.
13. SPARK ARRESTOR - CATALYTIC MUFFLER / MUFFLER -The muffler or catalytic muffler controls exhaust noise
and emission. The spark arrestor screen prevents hot, glowing particles of carbon from leaving the muffler. Keep
exhaust area clear of flammable debris.
14. FUEL TANK - Contains fuel and fuel filter.
15. RECOIL STARTER HANDLE - Pull handle slowly until starter engages, then pull quickly and firmly. When engine
starts, return handle slowly. DO NOT let handle snap back, or damage to unit will occur.
16. FUEL TANK CAP - Covers and seals fuel tank opening.
17. PRIMER BULB - Pumping primer bulb before starting engine draws fresh fuel from the fuel tank, priming the carbure-
tor for starting. Pump primer bulb until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an
additional 4 or 5 times.
18. AIR CLEANER - Contains replaceable filter element.
Advertisement
Table of Contents
