Hardware Management - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
About This Chapter
This chapter describes hardware management on the S9300, including power on and power off
of boards, electronic label backup, board reset, and master/slave switchover of the main control
boards.
4.1 Introduction to Hardware Management
This section describes the hardware management of the S9300.
4.2 Hardware Management Supported by the S9300
This section describes the hardware management operations supported by the S9300.
4.3 Powering On and Off the Board
This section describes how to power on and off the board.
4.4 Backing Up Electronic Labels
This section describes how to back up electronic labels.
4.5 Setting the Rotating Speed of a Fan
This section describes how to set the rotating speed of a fan.
4.6 Setting the Upper and Lower Thresholds of the Temperature of the Fan Module
This section describes how to set the upper and lower thresholds of the temperature of the fan
module to control the temperature range of the optical module.
4.7 Resetting the LPU
This section describes how to reset the LPU.
4.8 Resetting the Slave Main Control Board
This section describes how to reset the slave main control board.
4.9 Configuring Master/Slave Switchover
This section describes how to configure master/slave switchover.
Issue 03 (2011-12-29)
4

Hardware Management

Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Management
38