Displaying Diagnostic Information - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
----End
Example
<Quidway> display alarm all
----------------------------------------------------------------------------
Level
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
----------------------------------------------------------------------------

3.2.13 Displaying Diagnostic Information

You can use the display diagnostic-information command to collect the running information
of all modules for fault location instead of running all the related display commands.
Context
Do as follows on the S9300 whose diagnostic information is to be viewed.
Procedure
Step 1 Run:
display diagnostic-information
Diagnostic information about the S9300 is displayed.
Diagnostic information includes: clocks, versions, current configuration files, saved
configuration files, physical and protocol information about an interface, statistics on
transmitting and receiving of packets, memory usage, and system logs.
----End
Issue 03 (2011-12-29)
You can use the command in any view to view alarm information about the S9300. The
information displayed includes hot backup alarm, reboot alarm, hot swap alarm of the LPU,
or voltage alarm.
Date
2008-12-11
2008-12-11
2008-12-11
2008-12-11
2008-12-11
2008-12-11
2008-12-11
2008-12-11
2008-12-11
NOTE
Diagnostic information is lengthy and variable with devices. Therefore, no example of diagnostic
information here is provided.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Time
10:12:19 The "1.2V" voltage sensor of LPU board[9
](entity) exceed lower minor limit.
10:12:19 The "12V" voltage sensor of LPU board[9]
(entity) exceed lower minor limit.
10:12:19 The "2.5V" voltage sensor of LPU board[9
](entity) exceed lower minor limit.
10:12:19 The "1.8V" voltage sensor of LPU board[9
](entity) exceed lower minor limit.
10:12:19 The "1.25V" voltage sensor of LPU board[
9](entity) exceed lower minor limit.
10:12:19 The "1.05V" voltage sensor of LPU board[
9](entity) exceed lower minor limit.
10:12:19 The "3.3V" voltage sensor of LPU board[9
](entity) exceed lower minor limit.
10:12:15 The "1.0V" voltage sensor of SRU board[1
3](entity) exceed upper minor limit.
10:12:15 The "CLK_DET_50M" sensor13 of SRU board[
13] detect clock signal fault.
3 Displaying the Device Status
Info
34