Engine Oil; Stability Control (Esc) / Traction Control (Tcs) - Skoda yeti Owner's Manual

Hide thumbs Also See for yeti:
Table of Contents

Advertisement

Steering column lock not unlocked (System KESSY)
flashes - for vehicles with the KESSY system, the steering lock is not re-
leased.
Move the steering wheel slightly back and forth, thereby facilitating the un-
locking of the steering lock.
If the steering does also not unlock then, the help of a specialist garage is
required.
Steering lock defect (KESSY system)
An audible signal is heard as a warning.
flashes
 Steering column lock faulty.
Park the vehicle, do not continue to drive. After switching off the ignition,
it is no longer possible to lock the steering, to activate the electrical compo-
nents (e.g. Infotainment ), to switch on the ignition again and to start the en-
gine. Seek help from a specialist garage.
flashes
 Steering lock: Workshop!
You can drive on, exercising appropriate caution. Seek assistance from a spe-
cialist garage immediately.
Disconnecting the vehicle battery
If the vehicle's battery has been disconnected and reconnected, the indicator
light
comes on after switching on the ignition.
The warning light should go out after driving a short distance.
If, the indicator light does not go out after the engine is restarted and after a
short drive, then there is a system error.
You can drive on, exercising appropriate caution. Seek assistance from a spe-
cialist garage immediately.

Engine oil

Read and observe
on page 33 first.
Low oil pressure
flashes
 Oil pressure: Turn engine off! Log book!
Stop the vehicle, switch off the engine, and check the engine oil level.
If the warning light flashes ,
el is correct! Also do not leave the engine in idle mode.
Seek help from a specialist garage.
do not drive any further!even if the oil lev-
Engine oil level too low
Illumi-
 Check oil level!
nates
Stop the vehicle, switch off the engine, and check the engine oil level, top up
if necessary.
The warning light will go out if the bonnet is left open for more than 30 sec-
onds. If the engine oil is not refilled, the warning light will come on again after
driving about 100 km.
Fault on the engine oil level sensor
flashes
 Oil sensor: Workshop!
The warning light
flashes several times after switching on the ignition and
there is an audible signal.
You can drive on, exercising appropriate caution. Seek assistance from a spe-
cialist garage immediately.
CAUTION
If, under the given conditions, it is not possible to top up with engine
stop driving - there is a risk of engine damage! Switch off the engine and seek
assistance from a specialist garage.

Stability control (ESC) / Traction control (TCS)

Read and observe
on page 33 first.
If your vehicle is equipped with the ESC system, the TCS is part of the ESC sys-
tem.
flashes – the ESC or TCS is currently being activated.
System fault
illuminates – there is an ESC or TCS fault.
You can drive on, exercising appropriate caution. Seek assistance from a spe-
cialist garage immediately.
If the warning light comes on after starting the engine, the TCS may be
switched off for technical reasons.
Switch the ignition off and on again.
If the warning light
does not illuminate after you switch the engine back on,
the TCS is fully functional again.
oil,
Instruments and warning lights
35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents