Timing Belt Tension For The Y Direction - Brother PC8200 SUPER GALAXIE 2000 Service Manual

25.

TIMING BELT TENSION FOR THE Y DIRECTION

STANDARD
There should be 4 ± 1 mm slack in the timing belt when the center of timing belt at the Y drive shaft and Y tension
pulley is pressed with a force of 120g after the Y carriage is moved all the way forward.
ADJUSTMENT
1. Move the Y carriage all the way forward.
2. Loosen the screw of the Y tension pulley.(screw (C))
3. Adjust the position of the Y tension pulley.
4. Tighten the screw of the Y tension pulley.(screw (C))
Adjustment Point
If the tension in the belt is too weak or too tight, the embroidery may not be aligned correctly (the inside of the
pattern may not align with the outline).
-44-