Large One-Point Pattern Shape (Soft Adjustment) - Brother PC8200 SUPER GALAXIE 2000 Service Manual

16.

LARGE ONE-POINT PATTERN SHAPE (SOFT ADJUSTMENT)

STANDARD
When pattern adjustment "3" is selected in test mode and the start/stop button is pressed, the vertical and horizontal
separation of the test pattern outline should be 1 mm or less.
ADJUSTMENT
1. Select "3" pattern adjustment in the test mode.
2. Press the start/stop button and sew the test pattern outline.
* Install presser foot N before sewing.
3. Adjust the pattern.
Adjustment Points
1. If the pattern is compressed in the
If the pattern is stretched in the
If the pattern is compressed in the
If the pattern is stretched in the
2. The should be adjusted using the four settings for each direction.
* If the pattern cannot be adjusted using the four settings for each direction, refer to FEED ADJUSTMENT
(VERTICAL FEED) on page 39 and adjust the F pulse motor position.
direction, press the vertical
direction, press the vertical
direction, press the horizontal
direction, press the horizontal
-38-
button. (A)
button. (B)
button. (C)
button. (D)