Brother PC8200 SUPER GALAXIE 2000 Service Manual page 21

67. Attach the rear cover using the three screws.
68. Attach the needle plate assembly using the two screws.
69. Connect the five connectors, and attach the front cover using the three screws.
(When inserting the touch panel connector, confirm that the lock on the main board connector is open.)
When the front cover has been removed, always adjust the touch panel after assembling the front cover.
70. Insert and attach the thread guide cover.
71. Insert the base cover into the base plate and attach using the two screws.
72. Attach the belt cover using the screw, and fit the blind cap on.
73. Attach the free arm cover using the screw.
74. Attach the face plate using the screw.
Assembly Points
67. When installing the rear cover, lower the presser foot lifter, slightly lift the back of the unit, then install the rear
cover.
69. When installing the front cover, do not pinch the lead wires on the left side of the main PC board between the
cover and the sewing machine.
71. Check that the right side (A) of the base cover is securely attached to the bottom of the rear and front covers.
-19-