Blind Spot Assist - Mercedes-Benz MY17 c-class Operator's Manual

Instrument cluster display
Displaying the assistance graphic
Call up the assistance graphics display func-
X
tion using the on-board computer
( page 211).
Y
Select the Traffic Sign Assist display.
X
Detected traffic signs are displayed in the
instrument cluster.
Speed limit with unknown restriction
Maximum permitted speed
:
; Maximum permitted speed for vehicles for
which the restriction in the additional sign is
relevant
Additional sign for unknown restriction
=
A maximum permitted speed of 80 mph
(80 km/h) and a speed limit of 60 km/h
(60 mph) with an unknown restriction apply.
i
The unit for the speed limit (km/h or mph)
depends on the country in which you are driv-
ing. It is generally neither shown on the traffic
sign nor on the instrument cluster but must be
taken into account when observing the max-
imum permitted speed.
Lane Tracking package
General notes
The Lane Tracking package consists of Blind
Spot Assist ( page 191) and Lane Keeping
Y
Assist ( page 193).
Y
Driving systems

Blind Spot Assist

General notes
Blind Spot Assist monitors the areas on either
side of the vehicle that are not visible to the
driver with two lateral, rear-facing radar sen-
sors. A warning display in the exterior mirrors
draws your attention to vehicles detected in the
monitored area. If you then switch on the cor-
responding turn signal to change lane, you will
also receive an optical and audible warning.
Blind Spot Assist supports you from a speed of
approximately 20 mph (30 km/h).
Important safety notes
G
WARNING
Blind Spot Assist does not react to:
vehicles overtaken too closely on the side,
R
placing them in the blind spot area
vehicles which approach with a large speed
R
differential and overtake your vehicle
As a result, Blind Spot Assist may not give
warnings in such situations. There is a risk of
an accident.
Always observe the traffic conditions care-
fully, and maintain a safe lateral distance.
Blind Spot Assist is only an aid. It may fail to
detect some vehicles and is no substitute for
attentive driving. Always ensure that there is
sufficient distance to the side for other road
users and obstacles.
i
USA only:
This device has been approved by the FCC as
a "Vehicular Radar System". The radar sensor
is intended for use in an automotive radar
system only. Removing, tampering with, or
altering the device will void any warranties,
and is not permitted by the FCC. Do not tam-
per with, alter, or use in any non-approved
way.
Any unauthorized modification to this device
could void the user's authority to operate the
equipment.
Radar sensors
The radar sensors for Blind Spot Assist are inte-
grated into the rear bumper. Make sure that the
bumpers are free from dirt, ice or slush. The
sensors must not be covered, for example by
191
Z