Replacing Exciter Lamp; Replacing Fuse; About Kodak Publications - Kodak pagent 250s User Manual

Replacing Exciter Lamp

The exciter lamp (Figure 18) in this
projector operates at less than its rated
voltage. It should, therefore, have
extremely long life and should seldom
need to be replaced.
If the lamp must be replaced, remove
the master control cover as described
on page 16. Be sure that the power
cord is not plugged in. Push the exciter
lamp RELEASE L EVER down as far as it
will go. Turn the lamp counterclock-
wise and remove it.
Place the new lamp in the socket and
turn it until the large ends of the key
slots in the lamp base fit over the three
locating studs. The lamp will fit only
one way. Turn the lamp clockwise as far
as it will go. To lock the lamp in posi-
tion, raise the exciter lamp release
lever. Replace the master control cover.

Replacing Fuse

The fuse may be blown if the indicator
light (exciter lamp) fails to glow.
To remove the fuse, disconnect the
power cord, turn the fuse holder
counterclockwise by using a small
screwdriver, and withdraw the holder.
Replace the blown fuse with a fuse of
the value stamped on the amplifier
plate and replace the holder. If the
indicator light (exciter lamp) still fails
to glow, the problem could be in the
amplifier system. Consult a qualified
service representative to have the
amplifier repaired.
FIGURE 18
RELEASE LEVER

About Kodak Publications

Kodak Pamphlets: Precise, concise,
accurate information covering a large
variety of photographic subjects,
including audiovisual products and
their uses.
Kodak Books and Specialty Items:
DATAGUIDES, Data Books, packets,
catalogs. Authoritative, complete,
functional. Worthwhile additions to any
photographic library.
For a comprehensive listing of Kodak
publications, write to Eastman Kodak
412l,
Company, Department Roches-
ter, N. Y. 14650. Ask for a free copy of
Index to Kodak Information, Kodak
loS.
Pamphlet No.
SERIAL NUMBER
The serial number is stamped on
the nameplate on the amplifier
control panel. Make a record of
this number and keep it in a safe
place. The serial number should be
included in any correspondence
about the projector.
EXCITER LAMP
19