To Set Controls; Control Locations; Suggested Control Settings - Jenn-Air CU 23 SERIES Use And Care Manual

Updraft convertible grill-range cooktop
Table of Contents

Advertisement

Surface
Controls
The variable heat controls for the cooktop cartridges and grill element provide flexibility in
heat setting selection.
To Set Controls
• Since the controls are a push-turn type, they must be pushed down before turning. Toset
(from the OFF position), push down on control knob and turn in either direction to desired
heat setting.
• When control is in any position, other than OFF,it may be turned in any direction without
pushing down.
• A red indicator light will glow when a surface heating element is ON. There is a light for each
cooking bay area.
]
Control
Locations
:
1. Left rear heating element
or grill
2. Left front heating element or grill
_
3. Right front heating element
4. Right rear heating element
....
Energy-Saver
Note:
The Energy-Saver
grill element
(above,
right) is included
with the CU240
seris or may be
purchased as an option for the CU230. This permits utilizing only half of the grill area, if desired, or using
different
heat settings
for the front and rear position of the element.
When using this element,
both
cooktop controls, front and rear, must be turned on in order to use the full grill area. To use the standard
grill element, turn on the left rear control.
Suggested
Control
Settings
The size and type of cookware and the amount and type of food being cooked will influence the
setting needed for best cooking results. Electrical voltage may also vary; this will affect the
needed control setting. The setting indicated should serve as a guide while you become familiar
with your cooktop.
HI
A fast heat to start cooking quickly, to bring liquids to a boil, to preheat oil for deep fat
frying. Used for most grilling.
7-10
(Medium High) For fast frying or browning foods, to maintain rapid boil of large amounts of
food, to maintain oil temperature for deep fat frying.
5-6
(Medium) For foods cooked in a double boiler, sauteing, slow boil of large amounts of food.
3-4
(Medium Lo) Tocontinue cooking foods started on higher settings.
LO-2
Maintaining serving temperatures of foods, simmering foods, melting butter or chocolate.
The heat controls offer flexibility in heat setting selection. On settings other than HI, you may
adjust the controls above or below the numbered setting for best results. This applies to settings
when using cooktop cartridges or when using the grilt or any of the grill accessories. Suggested
settings are provided as general guidelines.
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cu 240 seriers

Table of Contents