Control Operation; To Set Controls - Jenn-Air A130 R Use And Care Manual

Control Operation
To Set Controls
• The induction cartridge is operated by using two controls, one on the range
and one on the induction cartridge, to control heat to the cooking surface to
be heated. (See Fig. H)
• To provide power to the cartridge, turn the range surface control knob for the
appropriate cooking surface from OFF to HI and leave it on this setting while
cooking. (See Fig. I) Using a setting other than HI voids the warranty.
Fig.H Fig.I
• Do not turn the range surface
control knob from the HI position.
On the HI setting, 100 percent
power is provided to the induction
cartridge. If the knob is turned
from HI to another setting, the
incoming power to the cartridge
will be reduced and the fan will
cycle on and off; this will affect
the cartridge's performance
(speed of cooking) and could dam-
age the cartridge. (See Fig. J)
• A red indicator light on the range
top will glow when a range surface
control is turned from the OFF
position. (Note: this light will glow
even if the induction cartridge is Fig. J
not properly installed).
• Use the slide control on the induction cartridge to regulate the degree of
power to the cooking area. When the induction slide control is set on the HI
setting, 100 percent of the power to the unit is available for cooking. As the
stide control is moved from the HI position, the percentage of power is
reduced. It is not necessary to move the slide control very much to increase
or decrease the desired heat to the utensil. Refer to the information on page
11 for suggested control settings. The line on the slide control knob
indicates the power level position. (See Fig. K)
10