Only For Training And Service Purposes - LG GB220 Service Manual

3. TECHNICAL BRIEF
3.7.1 Transmitter path
This module features a fully integrated zero IF transmitter. The baseband transmitted data Is digitally
modulated in the modem block and up-converted the 2.4GHz ISM band in the Transmitter path. The
transmitter path consists of signal filtering, I/Q up-conversion, high -output power amplifier(PA), and RF
filtering. It also incorporates modulation schemes P/4-DQPSK for 2 Mbps and 8-DPSK for 3 Mbps to support
enhanced data rate.
• Digital modulator
The digital modulator performs the data modulation and filtering required for the GFSK, ㅠ/4DQPSK, and
8-DPSK signal. The fully digital modulator minimizes any frequency drift Or anomalies in the modulation
characteristics of the transmitted signal and is much more Stable than direct VCO modulation schemes.
• Power Amplifier
The integrated PA for the BCM2070 is configurable for Class 2 operation, transmitting up to +4 dBm as well
as Class 1 operation and transmit power up to +12 dBm at the chip, gFSK, >2.5V supply. Due to the linear
nature of the PA, combined with some integrated filtering, no External filters are requires for meeting
Bluetooth and regulatory harmonic and spurious requirements. For integrated mobile handset applications,
where Bluetooth is integrated next to the cellular radio, minimal external filtering can be applied to achieve
near thermal noise levels for spurious and radiated noise emissions.
Using a highly linearized, temperature compensated design the PA can transmit +12 dBm for Basic rate and
+10 dBm for enhanced data rates(2 to 3 Mbps). A flexible supply voltage range Allows the PA to operate
from 1.2V to 3.0V. The minimum supply voltage at VDDTF is 1.8V to achieve +10dBm of transmit power.
3.7.2 Receiver path
The receiver path uses a low IF scheme to down-convert the received signal for demodulation in the
digital demodulator and bit synchronizer. The receiver path provides a high degree of Linearity, an
extended dynamic range, and high order on-chip channel filtering to ensure reliable operation in the
noisy 2.4GHz ISM band. The front-end topology, with built-in out -of-band attenuation, enables the
device to be used in most applications with no off-chip Filtering. For integrated handset operation where
the Bluetooth function is integrated close to the cellular transmitter, minimal external filtering is required
to eliminate the desensitization of The receiver by the cellular transmit signal.
LGE Internal Use Only
LGE Internal Use Only
- 46 - Copyright © 2009 LG Electronics. Inc. All right reserved.
Copyright © 2007 LG Electronics. Inc. All right reserved.

Only for training and service purposes

Only for training and service purposes