Table of Contents
Advertisement
5. DOWNLOAD AND CALIBRATION
LED Number
LED 1
LED 2
LED 3
LED 4
1. Connect as Fig 5-7(RS232 serial cable is connected between COM port of PC and MON port of
TEST JIG, in general)
2. Set the Power Supply 4.0V
3. Set the 3
rd
, 4
th
of DIP SW ON state always
4. Press the Phone power key, if the Remote ON is used, 1
D. Procedure
1. Connect as Fig 5-7(RS232 serial cable is connected between COM port of PC and MON port of
TEST JIG, in general)
2. Power on PC and enter into Windows 98(Remark: Windows 2000 system could be feasible)
3. Run HotKimchi.exe, the AUTOCAL application window will be appear.
Table 5-4. LED Description
Name
Power
TA
Indicate charging state of the phone battery
UART
Indicate data transfer state through the UART port
MON
Indicate data transfer state through the MON port
- 136 -
Description
Power is provided for Test Jig
st
ON state
Advertisement
Table of Contents
