Programming The Pbx; Easy Setup Wizard - Panasonic KX-NS1000 Installation Manual

5.4.1 Easy Setup Wizard

5.4 Programming the PBX

5.4.1 Easy Setup Wizard
In the Easy Setup Wizard, you will set up the mandatory settings required for the PBX.
When you log in to Web Maintenance Console for a PBX that is in its initialised, factory default state, the Easy
Setup Wizard for that PBX will launch automatically. You must log in using the Installer level account name
and password.
–
The Installer level account name is "INSTALLER".
–
The default Installer level account password is "1234".
1.
After Easy Setup Wizard launches, select a language, and then click Install.
2.
In Location Setting:
a.
Select a PBX Type:
•
Master: Select for a PBX that will be registered as the Master unit of One-look network. Also select
for a stand-alone PBX that will not be used in a One-look network.
•
Slave: Select for a PBX that will be registered as a Slave unit of a One-look network. If Slave is
selected, go to step 2-d below.
Note
If the Master unit is located on a different LAN than the Slave unit being registered, the Slave
unit will not be able to automatically detect the Master unit for registration. The IP address of
the Master unit must be specified. Enter the IP address of the Master unit in If located on
different network from Master PBX.
b.
Select a Suffix Code
c.
Select an Area
d.
Click Next.
Note
If Suffix Code is changed from its default value, a notice about restarting the PBX is displayed. Click
OK to restart the PBX. After the PBX restarts, start Web Maintenance Console again (refer to
"Connecting to Web Maintenance Console" in "5.3 Starting Web Maintenance Console"). When you
start the Easy Setup Wizard again, you will start from step 3, below.
*1 For information about Suffix Codes and Areas to select, refer to "9.1 PBX Region Suffix Codes and Areas".
3.
In PBX Setting:
a.
Specify a Site name if Master was selected for PBX Type in step 2.
b.
Select a Time Zone from the drop-down list.
c.
Click the Local Time box and select the date and time from the menu.
d.
Select one of the following options for Default value of Numbering Plan:
–
3 digits Extension Number (This type is recommended for under 8 sites)
–
4 digits Extension Number
–
3 digits Extension, 4 digits DISA & UM channel
Note
Depending on the value selected above, the numbering plan of the PBX will vary as follows.
Be aware that the default values for floating extension numbers and the number of available
UM groups are different.
220 Installation Manual
from the drop-down list if Master is selected for PBX Type.
*1
from the drop-down list if Master is selected for PBX Type.
*1