Electrolux W365H Service Manual page 35

Service
Manual
Errors with error codes
01E
Water level ACK not received within the
prescribed time.
Each time the machine is filled, it expects the
water level to reach the programmed level
within 10 minutes. Otherwise error code 01E is
generated.
First verify that:
• the inlet filter is not blocked
• all water faucets are open
• the drain is not leaking
• reset the error code by pressing the Start
button quickly. Continue with troubleshooting
if the error code appears again.
1. Enter the service programme and activate the water
Fig.
valves on the machine, one after the other (water
9
valves: code 11 - 18).
All valves fill up with water One of the valves does not fill
2. Activate the defective valve in the service
programme and measure the voltage (230 V) at
the water valve.
No voltage
3. Depending on the valve, measure the supply
Fig.
voltage (230 V) of the water valve at switch X35
9
or X36 on the card.
No voltage
Defective cables between the
communication card A11 and the water
valve, or programme unit card A21
defective. Verify and remedy.
The controller output on programme unit card A1 is
probably defective.
Continued on next page
438 9152-31/06
05.03
12. Troubleshooting
up with water
Voltage OK
The valve is probably defective.
Verify and remedy
Voltage OK
9
5183
Valve Switch
Y11, cold/warm,
compartment 1 X35:5
Y12, cold/warm,
compartment 2 X36:6
Y13, cold/warm,
compartment 3 X35:3
Y15, cold, mixing
compartment X36:5
Y22, warm,
compartment 1 X36:4
Y24, warm,
compartment 4 X35:2
Y25, warm, mixing
compartment X36:3
Y35, hard water, mixing
compartment X35:1
12
X36
X35
1
1
Code Relay
11 2
12 8
13 4
18 9
14 10
15 5
17 11
19 6
9