Gigaset DX800 Setting Up page 28

Hide thumbs Also See for DX800:
Table of Contents

Advertisement

Example: If your SIP address is "987654321@provider.com", enter
"987654321" as the Username.
Display name (optional)
Enter any name that should be shown in the other caller's display when you call
them via the Internet (example: Anna Sand). All characters in the UTF8 character
set (Unicode) are permitted. The name must not exceed 32 characters.
If you do not enter a name, your Username or your VoIP phone number will be
displayed.
Ask your VoIP provider if this feature is supported.
General data of your service provider area
If you have downloaded the general settings for the VoIP provider from the config-
uration server
from the download. Generally speaking, you do not need to configure any settings
in this area.
Domain
Specify the last part of your SIP address (URI) here (maximum 74 characters).
For the SIP address "987654321@provider.com", enter "provider.com" in
Domain.
Proxy server address
The SIP proxy is your VoIP provider's gateway server. Enter the IP address or the
(fully-qualified) DNS name of your SIP proxy server (maximum 74 characters).
Example: myprovider.com.
Proxy server port
Enter the number of the communication port that the SIP proxy uses to send
and receive signalling data (SIP port).
Port 5060 is used by most VoIP providers.
Registration server
Enter the (fully-qualified) DNS name or the IP address of the registrar server
(maximum 74 characters).
The registrar is needed when the phone is registered. It assigns the public IP
address/port number that were used by the phone on registration to your SIP
address (Username@Domain). With most VoIP providers, the registrar server is
identical to the SIP server. Example: reg.myprovider.com.
Registration server port
Enter the communication port used on the registrar. Port 5060 is used in most
cases.
Registration refresh time
Enter the time intervals (in seconds) at which the phone should repeat the
registration with the VoIP server (SIP proxy) (a request will be sent to establish a
session). The repeat is required so that the phone's entry in the tables of the SIP
26
Example
¢
(
page
24), then the fields in this area will be preset with the data
Example

Advertisement

Table of Contents
loading

Table of Contents