Table of Contents
Advertisement
11. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
Error Display
ERROR 2
The failure of a DVD/CD itself considered.
ERROR 3
1. A DVD/CD cannot be played due to
2. A DVD/CD cannot be played due to the
3.
ERROR 6
A DISC inside a DVD/CD cannot be played
because it is loaded upside-down.
ERROR R
Disc region code incorrect.
ERROR P
The view is limited.
ERROR 2
A CD inside the CD changer is not loaded.
ERROR 3
A CD inside the CD changer cannot be
played due to scratches, etc.
ERROR 6
A CD inside the CD changer cannot be
played because it is loaded upside-down.
ERROR 2
A DISC inside the DVD changer cannot be
played.
ERROR 3
A DISC cannot be played due to scratches,
etc.
ERROR 6
A DISC inside the DVD changer cannot be
played because it is loaded upside-down.
ERROR P
Parental level error
ERROR R
Region code error
AMP GUARD
The speaker protection circuit is operating.
During this operation, if any volume opera-
tion is performed, the display shows "AMP
GUARD".
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
46
VXZ646
Cause
scratches, etc.
defective pick-up part.
The disc is placed up side down.
Measure
Consult your store of your purchase or the
Clarion repair window.
Replace with a non-scratched,
non-warped-disc.
Eject the disc then reload it properly.
Use a disc with the correct region code.
Release the view limitation or change the
parental level.
(See the subsection "Setting up the
parental level".)
This is a failure of CD changer's mechanism
and consult your store of purchase.
Replace with a non-scratched, non-warped
disc.
Eject the disc then reload it properly.
This is a failure of DVD mechanism and con-
sult your store of purchase.
Retry or replace with a non-scratched, non-
warped-disc.
Eject the disc then reload it properly
Set the correct Parental level.
Eject the disc and replace correct region
code disc.
1. Turn down sound volume. Function can
also be restored by turning the power off
and on again.
(Speaker volume is reduced automati-
cally when the speaker protection circuit
operates).
2. If the sound is muted again, consult our
service department.
Advertisement
Table of Contents
