Table of Contents
Advertisement
3. Option buttons / display
3.8 Electronik cycle display
3.9 The intelligent doorlock
- This is a magneto - dynamic doorlock
- You have to open the door with the handle, which is not depending on the power source.
- Emergency opening with the knob on the base panel.
Before start- door is open
Before start – door
closed
After start – door closed
After the end of program
During the program cycle Off
3.10
Door locking conditions
If the door is closed and the machine started, the door is locked in any case.
If you push the break button the locking condition decide, if the machine can be opened.
The LED illuminates according to the locking conditions.
1.
Niveau
2.
water temperature
3.
Drum speed
4.
Broken tacho generator
TSE-N 01.2000 R.K.
- indicates the selected programe steps
- indicates the actual steps during the programe
- indicates the end of programe
- indicates at the end of programe „Overdosage"
that means to much detergent is used. The LED is only illuminated if
foam is detected during the first intermidiate spin.
Its active in all programes.
- indicates fault codes
Green
Red „blinking"
Grenn
Green
Green
Green
60°C
- 14 -
Door is open
Start button is pressed, while the
door is open.
Until E40 is shown.
Door can be opened with the handle
Door will be locked and LED stays
green
Door is unlocked and can be opened
with the handle.
Door is open
Door is locked due to level and
temperature
599 50 07-53/0
Advertisement
Table of Contents
