Table of Contents
Advertisement
3. Option buttons / display
3.6 Start / Pause
3.7 Multidisplay
TSE-N 01.2000 R.K.
- It starts the machine after the options and the desired
cycle is selected.
- Pressing the start / Pause button during a cycle, the
program stops and the start/pause LED blinks.
The locking condition decides, if the machine can be
opened. The door LED illuminates according to
the locking conditions.
- If the cycle is paused it's possible to add or eliminate
the extra rinse before it's executed.
The spin speed can be alternated until the final spin
has been performed.
During the breaktime the change of the programe isn't possible.
- To continue the cycle it's necessary to press the
start / pause button again.
- If you turn the selection switch during the programe
the machine continues with the previous started programe.
- It indicates pre-selected start time up to 19h
- Adjustable in steps of 1 h
- after the start time is chosen, the start button must be
pushed to activate the pre-selected start time.
The coundown begins in steps of 1 h.
- If the pause button is pressed during delay time,
the countdown is stopped and the door can be opened.
- It indicates the soaking time.
-
It indicates the estimated duration of a programe in minutes.
The suggested program time may be corrected automatically
during the cycle.
- The display also indicates the fault codes. ( E10 )
- In the customer service test program it shows the water level
- 13 -
599 50 07-53/0
Advertisement
Table of Contents
