Further details regarding the individual steps
Matching the control unit to the heating system
Note
Subject to the equipment level, the control unit must be matched to the system. Var-
ious system components are recognised automatically by the control unit and the
relevant codes are adjusted automatically.
In the following system designs, DHW heating is illustrated with a separate DHW
cylinder. The designs also apply to systems where DHW is heated by an integral
instantaneous water heater.
■ For the selection of an appropriate design, see the following diagrams.
■ For coding steps, see page 35.
System version 1
One heating circuit without mixer A1 (with/without DHW heating)
1
4
5
1 Vitodens 200-W
2 Outside temperature sensor (only
for weather-compensated control
units)
3 Vitotrol 100 (only for constant tem-
perature control units)
Required coding
Operation with LPG
Commissioning, inspection, maintenance
3
6
2
4 DHW cylinder
5 Cylinder temperature sensor
6 Heating circuit without mixer A1
(cont.)
Address
82:1
25