Light Emitting Diodes (Led) On Charger; Switching On - Stihl MSA 200 C Instruction Manual

English
Light Emitting Diodes (LED)
on Charger
1
The light emitting diode (1) on charger
glows continuously green or flashes red.
Green continuous light ...
... indicates the following:
The battery
is being charged
–
is too hot and must cool down
–
before charging
See also "Light Emitting Diodes (LEDs)
on Battery".
The green light emitting diode on the
charger goes off as soon as the battery
is fully charged.
74
Red flashing light ...
... indicates the following:
No electrical contact between
–
battery and charger – remove and
refit the battery
Malfunction in battery – see also
–
"Light Emitting Diodes (LEDs) on
Battery".
Malfunction in charger – have
–
checked by a servicing dealer.
STIHL recommends a STIHL
servicing dealer.

Switching On

When delivered, the battery is not fully
charged.
It is advisable to charge the battery
completely before using it for the first
time.
Before inserting the battery, remove
N
the battery compartment cover if
there is one; to do this, press both
safety catches at the same time –
cover is unlocked – and remove the
cover
Insert the battery
Insert battery in the battery
N
compartment of the machine –
press gently until it clicks into place
– top of battery must be flush with
the top edge of the housing
Switching on the machine
Assume a firm and secure stance
N
Ensure that there are no other
N
persons within the swivel range of
the machine
MSA 200 C