Wireless Stow-N-Go Laptop Mouse Wireless Stow-N-Go Laptop Mouse Introduction Congratulations on your purchase of the Targus Wireless Stow-N-Go Laptop Mouse. The Stow-N-Go receiver clips onto the mouse for ease of use while traveling or on the go. This is a plug and play device so no additional software is required.
Wireless Stow-N-Go Laptop Mouse Installing the Batteries 1. Remove the battery cover from the back of the mouse by sliding off the cover of the mouse. Hold the mouse in your hands and with the back of the mouse away from you. Press down on the corners of the battery cover and slide towards the back of the mouse.
Wireless Stow-N-Go Laptop Mouse Establishing the Connection (A) Remove the USB receiver from the bottom of the mouse. (B) Plug the USB receiver into an available USB port on your computer. (C) Press and release the setup key on the receiver. (D) Press the setup key on the bottom of the mouse.
Wireless Stow-N-Go Laptop Mouse Product Specification Transmitter 2405MHz-2477MHz Battery Type Alkaline battery AA Effective RF 10 meters max Communication Range RF output power 94.47dBuV/m Receiver 2405MHz-2477MHz Interface USB 1.1 Power USB Bus Powered 5V DC...
Declaration of Conformity Hereby, Targus Group International, declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Microsoft, Windows, and Windows Vista are either registered trademarks or trademarks of Mi- crosoft Corporation in the United States and/or other countries.