Suzuki gw250F Owner's Manual page 103

IGNITION SYSTEM CHECK
1. Remove the spark plug and reat-
tach it to the spark plug cap.
2. While holding the spark plug firmly
against the engine, push the
starter switch with the ignition
switch in the "ON" position, the
engine stop switch in the "$" posi-
tion, the transmission in neutral,
and the clutch disengaged. If the
ignition system is operating prop-
erly, a blue spark should jump
across the spark plug gap. If there
is no spark, consult your Suzuki
dealer for repairs.
! WARNING
Performing the spark test improp-
erly can be hazardous. You could
get a high voltage electrical shock
if you are not familiar with this
procedure.
Do not perform this check if you
are not familiar with the proce-
dure. Do not point the spark plug
near the spark plug hole during
this test. Do not perform this test
if you have a heart condition or
wear a pacemaker.
ENGINE STALLING
1. Make sure there is enough fuel in
the fuel tank.
2. If the fuel injection indicator dis-
plays "FI", showing signs of trou-
ble in the fuel injection system,
take your motorcycle to an autho-
rized Suzuki dealer. Refer to the
"INSTRUMENT PANEL" section
for an explanation of fuel injection
system indicator.
3. Check the ignition system for
intermittent spark.
4. Check the idle speed. The correct
idle speed is 1300 – 1500 r/min.
7-3