Craftsman 320.39596 Operator's Manual page 19

6. Reattach the filter and the upper cover to the box; firmly reinstall the box on
the sander.
_, WARNING: Collected sanding dust from sanding surface coatings such
as polyurethanes, linseed oil, etc., can self-ignite in the sander dust box or
elsewhere and cause fire. To reduce the risk of fire, always empty the dust box
frequently while sanding and never store or leave a sander without
totally emptying its dust box. Also follow the recommendations of the
coating manufacturers.
CLEAN THE DUST
CHUTE ACCESS
(Fig. 12)
Clean the dust chute before
storing the sander.
1. Disconnect the belt sander
from the power source.
2. Pull the dust chute access
out to remove it from the tool.
3. Use compressed air to Dust chute access
remove any objects from the
dust chute and interior of
the sander.
4. Insert the dust chute access into the tool again.
,_ WARNING: Always wear safety goggles or safety glasses with side shields
when using compressed air to clean the tool. If the operation is dusty, also wear
a dust mask.
PROBLEM SOLUTION
The sander does
not work
The sanding belt is not
centered on the rollers
during use
CAUSE
Not connected to
power source
The drive belt is broken
The sanding belt is not
adjusted properly
Plug the sander into a
power source
Have the belt replaced by a
qualified service technician
Adjust the sanding belt
tracking (see "ADJUSTING
THE BELT TRACKING")
The sanding belt Replace with a new
is defective sanding belt
19