Parts Breakdown - Wayne-Dalton 105/110 Installation Instructions And Owner's Manual

NOTE: The illustrations shown on this page are general
representations of the door parts. Each specific door
models may have unique variations.
F4. F6.
F2.
F3.
A2.
G11.
B3.
B1.
A3.
F7.
A. TRACk ROLLERS (AS REquIRED):
A1. Short Stem Track Rollers
A2. Long Stem Track Rollers
A3. Short Stem Tandem Track Rollers
A4. Long Stem Tandem Track Rollers
B. GRADuATED END HINGES:
B1. Single Graduated End Hinges (S.E.H.), Industry Standard
B2. Double Graduated End Hinges (D.E.H.), Industry Standard
B3. Half Center Hinges (As Required)
C. STACkED SECTIONS:
C1. Top Section
C2. Intermediate(s) Section (As Required)
C3. Bottom Section
D. TOP FIxTuRES (AS REquIRED):
D1. Top Fixtures
E. STRuT (S), u-SHAPED (AS REquIRED):
E1. Strut (2" And Or 3")
F. TRACkS (AS REquIRED):
F1. Left Hand and Right Hand Horizontal Track Assemblies
F2. Left Hand and Right Hand Riveted Track Assemblies (As Required)
F3. Left Hand and Right Hand Wall Angle Track Assemblies (As Required)
F4. Left Hand and Right Hand Vertical Track Assemblies (As Required)
F5. Left Hand and Right Hand Vertical Tracks (As Required)
F6. Left Hand and Right Hand Fully Adjustable (F.A.) Flag Angles (As Required)

Parts Breakdown

D1.
A1.
A2.
C1.
D1.
C2.
A1.
F1.
H2.
H1.
C2.
B2.
C3.
A2.
G10.
A1.
A4.
K1.
J1.
I1.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,
refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
F3.
F2.
F4.
F6.
G10.
E1.
F7.
I1.
J1.
G9.
G5.
G8.
G6.
F7. Left Hand and Right Hand Fully Adjustable (F.A.) Jamb Brackets (As Required)
G. TORSION SPRING ASSEMBLy (AS REquIRED):
G1. Center Bearing Bracket (As Required)
G2. Center Bracket (As Required)
G3. Center Bearing (As Required)
G4. Torsion Shaft/Torsion Keyed Shaft (As Required)
G5. Torsion Keyed Shafts (As Required)
G6. Keys (As Required)
G7. Center Coupler Assembly (As Required)
G8. Left and Right Hand Cable Drums
G9. Left and Right Hand Torsion Springs (As Required)
G10. Counterbalance Lift Cables
G11. Cable Sheaves
G12. Oval bearings (As Required)
H. REAR BACk HANGS:
H1. Left Hand and Right Hand Rear Back Hang Assemblies
H2. Left Hand and Right Hand Rear Center Back Hang Assemblies (As Required)
I. BOTTOM CORNER BRACkETS (AS REquIRED):
I1. Left Hand and Right Hand Bottom Corner Brackets
J. TRACk ROLLER CARRIERS (AS REquIRED):
J1. Track Roller Carriers
k. BOTTOM WEATHER SEAL (AS REquIRED):
K1. Bottom Weather Seal (Door Width)
2
G11.
H2.
F1.
E1.
H2.
G4.
G1.
G12.
G6.
G7.
G6.
G3.
G3.
G2.
G12.
G2.
H1.
G8.
G6.
G5.
G9.