System Start-Up Procedure - Mitsubishi FX3U-32DP User Manual

FX -32DP PROFIBUS-DP Interface Block
3U
User's Manual
1.5

System Start-up Procedure

Check of specifications
System configuration
Installation and wiring
Communication setting for 32DP
Turn ON power
Test run (communication test)
If error occurs, refer to Chapter 9.
FX -32DP
3U
Refer to Chapter 1
Outline
Refer to Chapter 2
Refer to Chapter 1 and 2
Refer to Chapter 3 and 4
Refer to Chapter 7
Refer to Chapter 7
Refer to Chapter 5 and 6
Create program
Refer to Chapter 9
1.5 System Start-up Procedure
Outline of system:
• Applicable PLC
• Applicable PROFIBUS configuration tool
Specifications:
• Operation environment
• Power supply specifications
• Performance specifications
System configuration:
Installation:
• Arrangements
• Mounting
Wiring:
• Applicable cable and connector
• PROFIBUS-DP wiring
• Bus terminator
Configuration setting:
• Create network configuration by configuration
tool
• Set parameter for DP-Master and DP-Slave
Configuration/Communication test:
• Change DP-Master to the Data Exchange Mode
• Check communication status (RUN LED)
Buffer memory:
• List of buffer memories
• Details of buffer memory
• For buffer memory read/write method,
refer to programming manual
Communication program:
→ For example program, refer to Chapter 8
• Cyclic communication program
• Acyclic communication program
1 Introduction
1
2
3
4
5
6
7
8
9
19