Amana B136CAL3 Technical Information page 26

Ice Maker Troubleshooting Chart
Contaminated
Jammed cubes
Notice size and density of cubes
Refrigerator or ice maker not level
No power to ice maker
Excessive water-fill volume
Cubes falling back into mold during
ejection
Contaminated
Thermostat out of calibration
Open heater circuit
Motor should oscillate
Little or no alumilastic on thermostat
Heater not staked in mold
Broken locking tabs on vertical cam
Contaminated
Insufficient water to ice maker,
small or hollow cubes
Contaminated
Motor will not oscillate
Shut-off arm stuck in ice or
obstructed
Cubes not formed properly
Contaminated
Cube frozen to fill cup or mold
12074208
3:00 Ejector Position
Replace module
Un-jam cubes
Level refrigerator or ice maker
Determine discontinuity by tracing power
Adjust module screw, lower water pressure, or
replace water valve
Replace fill cup
Check fill tube assemby
4:00 Ejector Position
Replace mold and heater assembly
Apply alumilastic
Replace thermostat
Apply alumilastic
Replace mold and heater assembly
Apply alumilastic
Apply alumilastic to thermostat
Replace mold and heater assembly
Apply alumilastic
Replace module
6:00 Ejector Position
Replace mold and heater assembly
Apply alumilastic
Refer to "Hollow Ice Cubes"
7:30 Ejector Position
Replace module
Remove obstruction
Replace module
Un-Jam
Check fill cup and fill tube assembly
9:00 Ejector Position
Replace module
Un-jam
Replace fill cup and module
26 February 1998