Disassembly Procedures - Amana B136CAL3 Technical Information

Ice Maker
Module Ohmmeter Checks
No Power to Ice Maker and
Ejector Blades in End of Cycle Position
Test Points Component
L - H Mold and heater
L - M Motor
Module Voltage Checks with Meter or Test Light
Power to Ice Maker
Test Points Component
L - N Module
T - H Bimetal
L - H Heater
L - M Motor
N - V Water valve

Disassembly Procedures

Cover
1. Pull water adjustment knob forward.
2. Snap off cover.
WARNING
!
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator using power switch before servicing.
Wires removed during disassembly must be
replaced on proper terminals to insure correct
earthing and polarization. After servicing,
reconnect power using power switch.
Mold attachment screw
access ports
February 1998
Module Position Ohms
Attached to support 264
Separated from heater 16,100
Line Voltage 0 Volts
Power on Power off
Open Closed
On Off
On Off
On Off
Shut off arm
Adjustment
screw
Module, Motor, and Support Assembly
1. Loosen both screws in module access ports.
2. Disconnect shut-off arm.
3. Pull mold from support assembly.
Remove module only by removing 3 screws and pulling
module out of housing.
Shut-Off Arm
1. Pull shut-off arm out from white bushing.
2. Replace by pushing completely in.
3. Follow steps below.
Module and Heater Assembly
1. Remove module and support assembly.
2. Install module and support assembly on
replacement mold and heater assembly.
Fill Cup
1. Remove module and support assembly.
2. Remove ejector blades and shut-off arm.
3. Pull fill cup from mold.
21 12074208