Power Cord - Campbell Hausfeld PW1605 Operating Instructions And Parts Manual

Operating Instructions and Parts Manual
Servicing of a Double - Insulated Appliance
(Continued)
Equipment damage
• ALWAYS turn water supply "ON" before turning
pressure washer "ON." Running pump dry causes serious
damage.
• Do not operate the pressure washer with the inlet
water screen removed. Keep screen clear of debris and
sediment.
• NEVER operate pressure washer with broken or missing
parts. Check equipment regularly and repair or replace
worn or damaged parts immediately.
• Use only the nozzle supplied with this machine.
• Never leave the wand unattended while the machine is
running.
• Never attempt to alter factory settings. Altering factory
settings could damage the unit and will void the
warranty.
• Always hold gun and wand firmly when starting and
operating the machine.
• NEVER allow the unit to run with the trigger released
(off) for more than one (1) minute. Resulting heat
buildup will damage pump.
• Pressure washer is not meant to pump hot water. NEVER
connect it to a hot water supply as it will significantly
reduce the life of the pump.
• NEVER store the pressure washer outdoors or where it
could freeze. The pump will be seriously damaged.
• Release trigger when changing from high to low
pressure modes. Failure to do so could result in damage.
Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine
hoses regularly and replace if damaged. Do not attempt to
mend a damaged hose.
www.chpower.com
Garden Hose Connection Instructions
1. Attach swivel adapter to pump water inlet, if not already
attached. Notice the swivel adapter is marked with the
words pump and hose. Make sure to connect pump side
of adapter to pump water inlet to prevent damage to
the threads.
2. Attach garden hose to swivel adapter side marked hose.
Figure 1 – Garden Hose Connection
3. The spray gun should be locked into the "OFF" position
by locating the safety trigger lock just above the trigger
of the gun. Activate the lock by holding the gun and
push the lock from left to right. Squeeze trigger to make
sure the trigger does not move. The safety trigger lock
should be locked at all times when pressure washer is
not in use.

Power Cord

Plug the power cord into a grounded 120 V outlet as shown
in Figure 2.
Figure 2 – Grounded Plug / Reset Button
4
Swivel Adapter
Garden Hose