Remove The Complete Stick From The Nozzle; Open The Upper Stick Assy And Lower Stick Assy - Philips FC7070 Service Manual

DISASSEMBLY- AND RE-ASSEMBLY ADVISE

Remove the complete stick from the nozzle.

To be able to open the Upper Stick assy and Lower Stick assy
the stick needs to be removed from the Nozzle, to do so
unscrew the screw K holding the Clamp in place. Carefully
open the Clamp and separate the Stick from the Nozzle.
Please notice to orientation of the several connectors inside
the joint. Within the joint are two electrical connections
and two water connections present. Especially the electrical
and small clean water connectors are fragile, considering
the weight of the stick, please handle them with care during
reinstallation.
At this point, also remove the Joint housing from the lower
stick by unscrewing the four screws F.

Open the Upper Stick assy and Lower Stick assy.

When a new appliance arrives at the consumer, the Upper
Stick assy is separated from the Lower Stick assy. The
consumer connects the Upper Stick assy to the Lower Stick
assy, this is a one-time only connection and cannot be undone
by the consumer. Service can disconnect these parts again.
First remove the ten screws
operate the two white clamps securing the internal electrical
connection from the Upper Stick assy to the Lower Stick
assy. You can now remove the Front Housing panel and access
the internal components
A
A
A
A
A
A
A
A
A from the Front Housing and
A
A
FC7070/01 /11 /61 /81
Secondly remove the ten screws
remove the Front Frame from the Lower Stick assy. You can
now access all internal components.
E
E
E
E
E
E
To exchange the PCBA in the Upper Stick assy, simply unlock
the Positive Lock Fastons from the PCB, unlock connector J3
and remove the PCBA from its holder.
J2
J3
E from the Front Frame and
E
E
E
E
3-9