Tri-Active Nozzle - Philips FC9239 Manual

The filter cylinder is not waterproof and cannot be cleaned with water or cleaning agents.
,
Only clean the filter with the Filter-Clean system.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and in accordance with the instructions in this instruction manual, the appliance is safe to
use according to scientific evidence available today.
Preparing for use
Connecting accessories
hose
1 To connect the hose, push it firmly into the appliance ('click'). (Fig. 2)
2 To disconnect the hose, press the release button (1) and pull the hose out of the appliance
(2). (Fig. 3)
Telescopic tube
1 Connect the tube to the handgrip of the hose by pressing the spring-loaded lock button on
the handgrip and inserting the handgrip into the tube. Fit the spring-loaded lock button into
the opening in the tube ('click'). (Fig. 4)
2 To disconnect the tube from the handgrip, press the spring-loaded lock button and pull the
handgrip out of the tube.
Use the same method to connect and disconnect the nozzles.
3 Adjust the tube to the length you find most comfortable during vacuum cleaning. (Fig. 5)

Tri-Active nozzle

The Tri-Active nozzle is a multi-purpose nozzle for carpets and hard floors. (Fig. 6)
,
The side brushes catch more dust and dirt at the sides of the nozzle and allow you to clean better
along furniture and other obstacles.
The opening at the front of the nozzle allows you to suck up larger particles. (Fig. 7)
,
1 To clean hard floors, push the rocker switch on top of the nozzle with your foot to make the
brush strip come out of the housing. At the same time the wheel will be lifted to prevent
scratching and to increase manoeuvrability. (Fig. 8)
2 To clean carpets, push the rocker switch again to make the brush strip disappear into the
nozzle housing. The wheel will be lowered automatically. (Fig. 9)
Crevice tool, small nozzle and small brush
1 Connect the crevice tool (1), the small nozzle (2) or the small brush (3) directly to the
handgrip or to the tube. (Fig. 10)
Accessory holder
The accessory holder can simply be snapped onto the handgrip. (Fig. 11)
,
The accessories can be stored in the accessory holder by pushing them into the holder. To detach
the accessories, pull them out of the holder.
You can store two accessories at a time in the accessory holder:
Crevice tool and small nozzle. (Fig. 12)
,
Please note the way in which the small nozzle must be placed in the accessory holder.
Crevice tool and small brush. (Fig. 13)
,
4222.003.3335.1.indd 7
English
7
03-07-2006 09:11:36