EIA bracket
Figure 50. EIA bracket installation
Step 3.
Install the screws to secure the EIA bracket to the chassis.
Note: Use the T8 torx wedge to install the screws.
Figure 51. Screw installation
Step 4.
Slide the server back into the rack until it latches.
Step 5.
Reconnect the external cables and power cords, if necessary.
Removing and replacing Tier 1 CRUs
Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request, you will
be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
Removing hot-swap hard disk drives
Use this information to remove hot-swap hard disk drives.
.
Chapter 5
Removing and replacing components
135