Navnet 3D, Pc - Furuno FAX-30 Operator's Manual

6. MAINTENANCE, TROUBLESHOOTING
3. Press the TEST soft key to start the test. The test results appear as shown
below.
Asterisk marks item
currently being tested
4. Press the RETURN key to escape from the test.
6.4.2

NavNet 3D, PC

The diagnostics test displays program no. And tests the ROMs and RAM,
receive ability and position data. The test results are displayed as OK or NG (No
Good). For any NG or abnormal value, contact your dealer for advice.
1. At the facsimile or navtex standby display, click FAX-30 SYSTEM SETUP.
2. Click TEST. The test results appear as shown below.
PROGRAM
SDRAM
RECEIVE
UNLOCK
LAT/LON*
3. Click STOP TEST to stop the test and restore normal operation and enable
receiving.
4. Click "<back" or Back button several times to return to the top menu.
6-4
PROGRAM NO.
* ROM1
ROM2
SDRAM
RECEIVE UNLOCK : OK
SS*1
SN*2
LAT/LON*3
0850188-XX
NO. 0850189-XX
ROM1 OK
ROM2 OK
OK
OK
OK
Diagnostic test results
TEST
0850188-XX
0850189-XX
: OK
: OK
: OK
: 60
: 60
: OK
RETURN
XX = Program Version No.
* = Requires data sentence GGA or GLL.
XX = Version no.
*1 SS = Signal Strength
Display Range: 0-99
Typical Reading: 30-70
*2 SN = Signal-to-Noise Ratio
Display Range: 0-99
Typical Reading: 20-60
*3 Requires data sentence
GGA or GLL, output
through the network.